Playground

An ESP32-C3 SuperMini, an OLED, LEDs, resistors, buttons and a supply. Wire them any way you like: the check works out the current through every part and tells you what would burn, what won’t boot and what can’t talk.

Start from:Button and LEDLED on a GPIOButton on a GPIOOLED on I²C

$ boardless check playground

    Tap a pin, then another, to wire them; drag a pin onto another works too. Select a part to change its value, rotate or delete it (R and Delete on a keyboard). Hold the button to press it. Select the C3 Mini to set what each wired GPIO does.

    What the check knows

    It solves the circuit the way a simulator does, so the currents are the ones Ohm’s law gives you on a bench. An LED doesn’t conduct until its forward voltage, about 2 V for red and yellow and 3 V for green, blue and white, and past that only the rest of the circuit limits the current. That’s why it needs a resistor in series.

    A typical 5 mm LED is rated for 20 mA continuously and survives about 30 mA. Backwards, it blocks up to 5 V. A common through-hole resistor takes 0.25 W. The check flags anything past those, and anything a button press would push past them.

    The ESP32-C3 SuperMini and the OLED

    The board is on USB: its 5V pin gives 5 V and its 3V3 pin 3.3 V. Each wired GPIO is an input (floating, pulled up or pulled down) or an output driving high or low, the way your sketch would set it. The check uses the C3’s datasheet limits: 3.6 V at most on a pin, about 40 mA out of one, and the strapping pins it reads at reset. IO9 held low starts the board in download mode. The rules are the same ones as onthe SuperMini’s page.

    Wire an OLED’s SDA and SCL to two GPIOs and they become an I²C bus. The check looks for power, a shared ground, and the pins that make a bus misbehave: IO8 flickers the onboard LED, IO9 is the BOOT button, IO21 carries the boot log. When nothing’s wrong, the screen shows the “Hello” from the OLED’s page.

    Boardless runs these checks on your whole project

    I’m building Boardless to check your schematic, case and firmware against each other on every change. The rules on this page are some of the first ones it knows.

    Used only to tell you when Boardless is ready and to decide what it supports first. No newsletter, no sharing. See the privacy note.