I killed three ESP32-C3s and never found out which wire did it
I wired a Waveshare resistive touch LCD to an ESP32-C3 the way Claude Opus 5.5 told me to. Three boards later, my computer wouldn’t recognise any of them, and I still don’t know which wire did it.
What happened
The display was a Waveshare resistive touch LCD. It has a lot of pins: power, the display bus, the touch controller, the backlight. More wires than I wanted to work out by hand, so I asked Claude Opus 5.5 for the wiring and followed it.
After that, the computer stopped recognising the ESP32-C3. Other boards still showed up on the same machine, so it wasn’t the cable or the port. The board was dead.
To find out what went wrong, I wired a second board the same way. It died too. So did the third. At about 350 Turkish lira each, that’s 1,050 lira, around $22.
The money wasn’t the expensive part
Three boards isn’t much. What hurt is that I never found the cause. I went back over the wiring, I asked the AI to find the mistake, and neither of us could point at the wire that did it.
In software, when you don’t know what broke, you run it again and watch. That’s what I did here, and each run cost a board. I didn’t want to lose a fourth one finding out, so I stopped.
The AI didn’t check, and neither did I
The wiring I got looked reasonable. Every line said this pin goes to that pin. What it didn’t do was hold each wire up against what the two parts can actually take, and I didn’t either. I trusted the list.
Those limits are written down. An ESP32-C3 runs at 3.3 V and its inputs take at most 3.6 V. The 5V pin on a C3 board carries 5 V whenever USB is plugged in, and a module powered from it can push 5 V back into a GPIO through its outputs or its pull-ups. A display board with that many pins has its own power pins and its own levels. All of it is in the datasheets. None of it was on the page I was wiring from.
I can’t tell you it was a 5 V line. That’s the point: I don’t know, and I found out the expensive way that guessing isn’t free.
What I want instead
Every wire checked against both parts before anything gets power: which voltage leaves one pin, what the other pin can take, which supply feeds what. If a line is wrong, I want to see it on the drawing, not find out from a board that no longer shows up on USB.
That’s the first check in Boardless. The ESP32-C3 pin check is a small version of it: pick a module pin, then a pin on the C3, and it tells you what’s wrong before you solder.
Sources
- ESP32-C3 datasheet v2.4: supply and GPIO input voltage limits.
- nologo.tech ESP32-C3 SuperMini wiki: 5V pin input range.
Boardless checks your wiring before you build it
I’m building Boardless to check your schematic, case and firmware against each other on every change. Join the waitlist to try it early.
You're on the list.
Got a minute? Tell me which boards you use and I'll know what to support first.